QCC connection with Quadro 5.2.46 or above

harryb · 01-21-2012, 02:54 PM

If you are using QCC be aware that after upgrading a Quadro to firmware release 5.2.46 or higher you may encounter connection problems.

QCC appears to use the new admin "phone access password" to connect rather than the "GUI admin password"

This is not reflected in the QCC documentation

Ashot · 01-27-2012, 12:44 PM

Hi,

Thank you for mentioning this issue. Actually this is a SW bug caused by Admin password management enhancement. It should be fixed in the Quadro 5.3.x SW vesions. Meanwhile it is reflected in the release notes for QCC

Thanks
Ashot

01-21-2012, 02:54 PM	#1
harryb Junior Member Join Date: Jun 2008 Location: St Albans, UK Posts: 23	QCC connection with Quadro 5.2.46 or above If you are using QCC be aware that after upgrading a Quadro to firmware release 5.2.46 or higher you may encounter connection problems. QCC appears to use the new admin "phone access password" to connect rather than the "GUI admin password" This is not reflected in the QCC documentation

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ip connection cannot be accomplished	serviplexSIP	Troubleshooting and Problems	8	01-19-2010 09:22 PM
Second VPN connection	fpwgmbh	Troubleshooting and Problems	1	10-08-2009 12:49 PM
Quadro 4x-RM PPTP Connection	HornetSoftIT	Troubleshooting and Problems	2	06-17-2009 07:18 PM
'IP Connection Cannot Be Established'	yellowgrid	Troubleshooting and Problems	1	07-23-2008 03:28 PM

01-27-2012, 12:44 PM	#2
Ashot Senior Member Join Date: Dec 2006 Posts: 254	Hi, Thank you for mentioning this issue. Actually this is a SW bug caused by Admin password management enhancement. It should be fixed in the Quadro 5.3.x SW vesions. Meanwhile it is reflected in the release notes for QCC Thanks Ashot

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)