Power failure- "FAULT" LED shows up

sgaddam · 10-20-2009, 04:55 PM

We have an unexpected power failure, after that FAULT & INFO LED lights shows up continuosly even though i restart, not able to login too.

davrays · 10-21-2009, 08:17 PM

How do theu blink? I mean do FAULT & INFO LEDs blink in sequence, or together?

It is very possible that your device has entered to the emergency recover state, and you will have to proceed with emergency recover procedure... That is described on the CD which you got with Quadro.

But before trying that, it worth to try something else (as the recovery procedure will reset the configurationof your device). Did you try to unplug the device from the power and power it again in a minute?
If this doesn't help, your second option is to factory-reset the unit, and try to connect from the LAN side to the IP 172.30.0.1. If that doesn't help too, you have to do emergency recover procedure.

10-20-2009, 04:55 PM	#1
sgaddam Junior Member Join Date: Oct 2006 Location: Alpharetta Posts: 9	Power failure- "FAULT" LED shows up We have an unexpected power failure, after that FAULT & INFO LED lights shows up continuosly even though i restart, not able to login too.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
"System Overload" MG note: G729 codec's limit	cwlinde	Troubleshooting and Problems	5	02-03-2010 09:06 PM
Quadro 16x - SIP Phone show "Network error" when dialing	DuettoFavorit	General Discussions	1	04-01-2009 09:55 PM
incoming calls with "unknown number"	dolmen	Tips and Tricks	5	12-22-2008 10:13 PM
Voice mail message sound is "dial tone" except words.	riskdata	Troubleshooting and Problems	2	10-20-2008 05:09 PM
Use built-in TFTP server to provision "Other" phones	mobidutch	Suggestions and Feedback	3	03-18-2008 02:37 PM

10-21-2009, 08:17 PM	#2
davrays Quadro Architect Join Date: Jun 2006 Location: Around myself Posts: 2,083	How do theu blink? I mean do FAULT & INFO LEDs blink in sequence, or together? It is very possible that your device has entered to the emergency recover state, and you will have to proceed with emergency recover procedure... That is described on the CD which you got with Quadro. But before trying that, it worth to try something else (as the recovery procedure will reset the configurationof your device). Did you try to unplug the device from the power and power it again in a minute? If this doesn't help, your second option is to factory-reset the unit, and try to connect from the LAN side to the IP 172.30.0.1. If that doesn't help too, you have to do emergency recover procedure.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)