To much time in the ringing between ext

mexel · 04-18-2007, 12:57 PM

Hi,
When I make calls between analog extensions, after I
dial the extension it takes to much time (15 -20 secs) to begin ringing the
dialed extension.

Do you have some tip to reduce the time?

Thanks

Marco A

threebit · 04-18-2007, 01:23 PM

Have you added many rules to the Call Routing table? If there are large numbers of similar rules in the table then the Quadro sometimes can take a long time to choose the best rule.

mexel · 04-21-2007, 05:35 PM

No, I only have the default and two more rules.

threebit · 04-22-2007, 12:43 PM

If you press # after the extension no. does it start ringing straight away or is there still a delay?

awhite · 04-27-2007, 07:13 PM

All phone systems have to deal with the problme of knowing when the user has finished dialing so that it can begin to perform the call routing. The Quadro does this with a dial time out option found under Telephony/Dial Timeouts. You can adjust this down to 2-3 seconds for most users. As mentioned previously, you can always use a # sign at the end of dialing to signify end of digits.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Caller ID and Distinctive Ringing	afuchs	'How Do I' Questions	2	10-16-2007 10:33 AM
Ringing Patterns	bragnet	'How Do I' Questions	3	08-30-2007 10:21 PM
Many Ext Ringing over Distributed Network	seropeco	'How Do I' Questions	1	05-25-2007 11:26 PM
Ringing Groups	alliance	'How Do I' Questions	1	02-22-2007 09:34 AM
Many Line Ringing (CELL PHONE)	nortex	'How Do I' Questions	5	09-27-2006 01:07 AM

04-18-2007, 12:57 PM	#1
mexel Junior Member Join Date: Jul 2006 Location: Mexico Posts: 3	Hi, When I make calls between analog extensions, after I dial the extension it takes to much time (15 -20 secs) to begin ringing the dialed extension. Do you have some tip to reduce the time? Thanks Marco A

04-18-2007, 01:23 PM	#2
threebit Moderator Join Date: Jun 2006 Location: New Zealand Posts: 210	Have you added many rules to the Call Routing table? If there are large numbers of similar rules in the table then the Quadro sometimes can take a long time to choose the best rule.

04-21-2007, 05:35 PM	#3
mexel Junior Member Join Date: Jul 2006 Location: Mexico Posts: 3	No, I only have the default and two more rules.

04-22-2007, 12:43 PM	#4
threebit Moderator Join Date: Jun 2006 Location: New Zealand Posts: 210	If you press # after the extension no. does it start ringing straight away or is there still a delay?

04-27-2007, 07:13 PM	#5
awhite Administrator Join Date: Jun 2006 Location: United States Posts: 50	All phone systems have to deal with the problme of knowing when the user has finished dialing so that it can begin to perform the call routing. The Quadro does this with a dial time out option found under Telephony/Dial Timeouts. You can adjust this down to 2-3 seconds for most users. As mentioned previously, you can always use a # sign at the end of dialing to signify end of digits.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)