Yealink T-28 DSS keys on analogue trunk

Flames86 · 03-16-2012, 08:50 AM

Hi All

I have an epygi 8ml, and a yealink T28P, 5 incoming analogue trunks and would like to configure it so that when theres an incoming call, the dss keys next to the screen lights up accordingly to which ever trunk the key is configured to. I'm not to sure whether this configuration would be mainly on the Epygi or Yealink. As far as I know, the T-28P can handle up to 6 lines. Im just not sure how to assign each line to an analogue trunk. Any assistance appreciated...Thanx

AManukyan · 03-16-2012, 02:30 PM

Hello
You can do this scenario by following steps.

1. Add new virtual extension(555)(don't attach IP Line).
2. Set Ringing Simulation Timeout(for example 10sec) on this extension (on extension General Settings page)
3. Route FXO calls to (555) extension (Telephony->FXO Settings page)
4. Configure watching ext. 555 for Yealink T-28 phone Line Key(next to screen) from (Telephony->Line Settings->Advanced)

So, when call comes from FXO which routed on ext 555 on Yealink phone line key will blink.
Do similar configuration for other FXO lines.

03-16-2012, 08:50 AM	#1
Flames86 Junior Member Join Date: May 2011 Posts: 4	Yealink T-28 DSS keys on analogue trunk Hi All I have an epygi 8ml, and a yealink T28P, 5 incoming analogue trunks and would like to configure it so that when theres an incoming call, the dss keys next to the screen lights up accordingly to which ever trunk the key is configured to. I'm not to sure whether this configuration would be mainly on the Epygi or Yealink. As far as I know, the T-28P can handle up to 6 lines. Im just not sure how to assign each line to an analogue trunk. Any assistance appreciated...Thanx

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Yealink IP Phone provisioning	tsim	Installation	2	11-14-2011 12:22 AM
Yealink Configuration	SITEL S.A	'How Do I' Questions	3	12-19-2010 09:48 AM
Best Analogue phones	lambsons	Installation	1	05-29-2008 04:06 AM
Transfer from analogue	LightSpeed	'How Do I' Questions	3	09-26-2007 08:48 PM
Sip trunk to Sip Trunk transfer	definitel	Problem Report	1	03-31-2007 07:09 PM

03-16-2012, 02:30 PM	#2
AManukyan Member Join Date: Jan 2011 Posts: 85	Hello You can do this scenario by following steps. 1. Add new virtual extension(555)(don't attach IP Line). 2. Set Ringing Simulation Timeout(for example 10sec) on this extension (on extension General Settings page) 3. Route FXO calls to (555) extension (Telephony->FXO Settings page) 4. Configure watching ext. 555 for Yealink T-28 phone Line Key(next to screen) from (Telephony->Line Settings->Advanced) So, when call comes from FXO which routed on ext 555 on Yealink phone line key will blink. Do similar configuration for other FXO lines.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)