|06-27-2007, 04:32 AM||#1|
Hi! So I've up to 20 quadros connect in a private VPN and I need to add the same rules on the Call Routing Table on each one, i'm trying to use the Legible Configuration file of one of them, but in the end of the upload it's give me an error:
# calling lcrwizard.cgi returned an error! "
I verifed the file many times, the version of firmware is correct,
and cannot see any error, is there way to verife the returned error?
anyone tried this kind of upload?
Best Regards, tks!
|06-28-2007, 03:41 AM||#2|
Join Date: Jun 2006
Below are some short instructions to help you add a call
routing record with a legible configuration file (LCF). The steps are applicable
to SW 4.1.x.
the call routing table contains at least one entry of your desired call routing
type (SIP, PSTN, etc.). The LCF for this routing will be used as a template for the new entry.
a LCF for the Call Routing page.
the generated LCF, remove all lines except for those corresponding to a single entry
(of the desired call type, of course).
those lines, change the occurrences of the routing number to add and edit the desired
If you are adding
multiple entries, please ensure to insert commit=1 to separate the lines corresponding to different entries.
Here comes a short example:
If this doesn't
help, please, post the LCF you have created so that we can see what the
|06-28-2007, 06:04 AM||#3|
Hi Liana! tks, it's done now! it was missing the "commit=1" It save me 30 lines of configuration[img]smileys/smiley2.gif[/img] on each quadro
tks a lot
|06-12-2009, 10:49 AM||#4|
Join Date: May 2009
Don't work for me.
If I create new routing line, --> # calling lcrwizard.cgi returned an error! "
I can edit an existing routing line but can't create new.
Boot loader: 4.1.35/Release
Firmware Version: 5.1.18/Release
|06-12-2009, 01:17 PM||#5|
Join Date: Jun 2006
Location: Around myself
I tested this with 5.1.17 (copied the example above, changed the "4.1.26" with "5.1.17" and applied) - works without any problem.
I can just make guess why it doesn't work on your case: if you have already a rule with the similiar parameters, the new one may fail to add. Check your table to see if you already have a rule with similiar pattern/NDS/call type...
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Time Configuration between Epygi /Phones||CarpeDiem||Troubleshooting and Problems||1||01-28-2011 05:59 PM|
|Pattern configuration||ssteiner||Installation||11||05-15-2008 11:37 AM|
|Configuration Deployment||riskdata||'How Do I' Questions||1||05-24-2007 08:20 PM|
|Auto configuration on a remote extension||Totalcomsol||Tips and Tricks||2||05-02-2007 06:03 PM|
|Home configuration scenario||ghutton||'How Do I' Questions||1||12-19-2006 08:07 PM|