Stacking Quadro 2xi

darylp · 04-01-2008, 05:13 PM

Howdy,
I'd like to stack Quadro 2xi units, to share the ISDN2 services.
However, I only want share a single channel of each ISDN2 service, to still allow incoming calls.

How could this be achieved?
If it cannot, can this be submitted as a feature request?

AramK · 04-02-2008, 07:32 AM

Such option is already available on Quadro. For share only one ISDN channel you need to add a new routing rule, select the Trunk on the 2nd page of wizard and define the timeslot/channel which you want to share on the 3rd page. Write me if you need more explanation on this.

darylp · 04-03-2008, 10:35 AM

Thanks Aramk!
Ah!! thats what timeslot means. Saw that added with the 4.1.52 firmware.
Too easy...

04-01-2008, 05:13 PM	#1
darylp Senior Member Join Date: Oct 2006 Location: HORNSBY, NSW, Australia Posts: 119	Stacking Quadro 2xi Howdy, I'd like to stack Quadro 2xi units, to share the ISDN2 services. However, I only want share a single channel of each ISDN2 service, to still allow incoming calls. How could this be achieved? If it cannot, can this be submitted as a feature request?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Automatic, stacking of two quadros	viptelprueba	General Discussions	0	02-26-2007 06:50 AM
Stacking - Unified Extension Directory	threebit	Suggestions and Feedback	0	02-07-2007 01:03 PM

04-02-2008, 07:32 AM	#2
AramK Senior Member Join Date: Sep 2006 Location: Yerevan Posts: 796	Such option is already available on Quadro. For share only one ISDN channel you need to add a new routing rule, select the Trunk on the 2nd page of wizard and define the timeslot/channel which you want to share on the 3rd page. Write me if you need more explanation on this.

04-03-2008, 10:35 AM	#3
darylp Senior Member Join Date: Oct 2006 Location: HORNSBY, NSW, Australia Posts: 119	Thanks Aramk! Ah!! thats what timeslot means. Saw that added with the 4.1.52 firmware. Too easy...

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)